7510W Panel Hanging Plates 200mm x 100mm Self Adhesive Kit with hooks

A quick and economical way to hang prints on lightweight substrates including Chromaluxe, DiBond, Fomex, and acrylic. They allow the panel to hang on almost any hook, nail or screw.

Technical Information

• Backed with a high-quality polyethylene foam pad coated with an aggressive pressure sensitive adhesive.

• The peel strength of the adhesive is rated to 25 N/25 cm. The strength of the adhesive in use can vary depending on environmental factors, the method of application and the type of substrate. As these are out of our control, we cannot give advised weight limits, users will need to make their own assessment. We do not recommend these hangers for use on valuable artwork. See data sheet for more information.

• Never thread cord or wire between two hanging plates as this can pull the plates away from the panel.

• Using two hanging plates does not improve performance. One larger hanging plate performs better than two smaller hanging plates.

Cleaning & Application

• The panel must be cleaned and degreased using Isopropyl Alcohol Wipes / Spray before the panel hanging plate is fixed in place. For best results allow 24 hours for the adhesive to cure before hanging.

• Apply only to clean, dry, flat, dust-free and non-porous substrates. Not suitable for soft surfaces such as paper, mountboard, or similar.

• Bumpers can be placed at each bottom corner to help the panel hang flat on the wall. Do not place bumpers on the top corners as the can cause the plate to pull away from the panel.

See also:

Easy Level Panel Hanging Plates