9980B Panel Hanging Plates Easy Level 80mm x 80mm pack 50 pairs

A quick and user-friendly way to hang prints on substrates including Chromaluxe, DiBond, Fomex, and acrylic. The angled micro sawtooth hanging bridges allow the panel to be easily levelled with a little lift and nudge side-to-side.

The panel hangs on a pair of hooks, nails or screws. The panel hangs on a pair of hooks, nails or screws – the angled sawtooth means they don’t have to be perfectly level.

Technical Information

• Backed with a high-quality polyethylene foam pad coated with an aggressive pressure sensitive adhesive.
• The peel strength of the adhesive is rated to 25 N/25 cm. The strength of the adhesive in use can vary depending on environmental factors, the method of application and the type of substrate. As these are out of our control, we cannot give advised weight limits, users will need to make their own assessment. We do not recommend these hangers for use on valuable artwork. See data sheet for more information.
• Never thread cord or wire between two hanging plates as this can pull the plates away from the panel.

Cleaning & Application

• The panel must be cleaned and degreased using Isopropyl Alcohol Wipes / Spray before the panel hanging plate is fixed in place. For best results allow 24 hours for the adhesive to cure before hanging.
• Apply only to clean, dry, flat, dust-free and non-porous substrates. Not suitable for soft surfaces such as paper, mountboard, or similar.
• Bumpers can be placed at each bottom corner to help the panel hang flat on the wall. Do not place bumpers on the top corners as the can cause the plate to pull away from the panel.

See also:

Panel Hanging Plates